eSky Helicopter
Transmitter Mode Change:
Mode 1 (Right hand throttle)VS Mode 2 (Left Hand Throttle)
This document show you how to
change the Mode 1 Transmitter to Mode 2 Transmitter for eSky
Transmitter
eSky Helicopter Mode 1 Transmitter with right
hand throttle
Mode Change Step 1: - Take off the 4 screws on the back of the transmitter.
Step 2: Open up the transmitter after you took
off the 4 screws on the back of the transmiter
Step 3: - Now take off the 4 little screws from the control wires
set inside the transmitter - indicated by red color rectangles
in the images below.
Step 4: - Pull out the control wires set after you took off the 4
little screws
- First pull out the left hand side one, then the right hand
side one too.
Pull out the wires set on the left as show
Now pull off the right hand side wire set as
show above
Step 5: - Now, exchange the wires sets - Install the
original left hand one to right hand side andthe
original right hand side wire set to the left hand side. This is
the main part of change mode.
After exchange the wires set, then install back the wires set.
Step 6: - Tight up the 4 little screws back to the transmitter to
secure the wire sets after exchange them
Step 7: - Change the metal clip from left to the right hand side as
shown below
Step 8: - Install the antenna and the sim port
Step 9: - Assembly the transmitter by tighten up the 4 screws on the
back
Step 10: - IMPORTANT STEP: Change the setting by adjust 2 switches in
front of the transmitter as shown below:
Mode 1 Original Setting
Mode 2 Setting - you must change the 4
switches like this setting after you changed mode from mode
1 to mode 2
